Menu

Salvage 2+

    Rate this item
    (0 votes)
    salvage2

    Salvage 2+ is a rust encapsulator, primer and top coat that stops rust in its tracks with a single coat and provides a hardwearing chip resistant top coat

    • Three products in one – encapsulates, primes and top coat
    • Utilizes the latest hybrid technology
    • Outstanding corrosion resistance - passed 3000 hour scribed hot salt spray test ATSM B117
    • Fast application- minimum surface preparation required can be applied by brush, roller or sprayer
    • Pot life of up to 2 hours, which is ideal for larger applications
    • Can be over-coated if required

    Typical application areas

    Salvage 2+ is recommended as a rust treatment system, providing a rust encapsulator and top coat in one product.

    Ideal for treating corroded steel structures typically:

    • Pipe work
    • Tanks
    • Pressure vessels
    • Suspended flooring and walk ways
    • Overhead crane rails
    • Sections on lifting cranes

    Industries:

    • Chemical and Wastewater
    • Construction and Manufacturing
    • Petroleum and Petrochemical
    • Pulp and Paper
    • Transportation (railroad, automotive)

    Directions

    Salvage 2+ preparation

    Surface Preparation:

    Remove any visible oil, grease, dirt or other contaminants, with a degreaser or by steam cleaning, followed by a clear water rinse. Remove loose corrosion by wire brushing, either by hand or using a power brush. All loose material must be removed prior to application and the surface should be fully dried.

    Salvage 2+ being applied

    Application:

    Stir Part A and slowly add to Part B. Then stir constantly with a mixer at low speed (300 - 400 rpm) or manually with a spatula. Mix until a uniform paint has been produced.

    Apply by brush, roller or spray. Note: Pressure pot sprayers may require the product to be thinned 5-10% using a xylene based thinner.

    Multiple coats may be required, allow drying for 10 hours between coats. For smaller curved intricate areas, use of a brush is recommended.

    Higher ambient temperatures will accelerate the drying time.

    Do not apply at temperatures below 5ºC. Store at temperatures between 10-30ºC.

    Contact Us

    Interested in knowing what we can do for you?

    Interested in being part of our team? Take a look around our careers pages to find out where your career could begin with NCH Asia.

    Contact us